![]() In all, the R&R took approx 10hrs with included mods + drilling out hub caps with 4.5" hole saw. Top Ball joints speced at 0.008" & bottom Ball joints were tight. I checked ball joints with magnetic dial indicator. ![]() Had to polish stub shaft where ujoint caps due to being too tight for my liking. Had to grind down spindles to fit ABS sensors, studs 1/4" shorter than factory. Components seemed to be high quality, forged spindles, 4140 chrome moly 1.5" 35splined outer stub shafts (factory = 1.25" 30 spline), timken bearings, warn hubs. Will stick out less when I install aftermarket rims with 4.5" baqckspacing compared to factory 6" back spacing. ![]() Found Yukon kit for $1750CAD all in delivered to my door. Backordered 4-6weeks from sites I researched. Decided to go this route cause it seems spyntec can't keep up with demand.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |